AlgidAgent used to destroy green algaeColourless concentrated liquidIntended for professional and general use Algid is an agent used to destroy green algae that have formed on wood and stone surfaces. It is a colourless concentrated liquid, intended for professional and general use. ShareUseTechnical data Informative calculation of consumption Material safety data sheets Before use, shake bottle with Algid and thin with water at about 20 °C, in the following ratio: 1 part Algid and 4 parts water. Moisten the surface infected with algae with water first. Apply the solution with a brush, a roller, or by spraying. Protective clothing should be worn when using this product. When spraying, direct the agent to the infected surface as much as possible to avoid spraying the surrounding area. Protect nearby plants with a protective film. Only use the product at a temperature above +8 °C. The surface must not be exposed to rain while the agent is left to work.After a few hours, the algae on the surface become discolored and die. After 24 hours, brush the surface to remove the algae manually and rinse with water. Repeat the process in case of severe infestation.If needed, coat the wooden surfaces with solvent-based woodstain after cleaning; as additional protection we recommend using Belprotect.1 l of thinned agent (1:4) is enough for the remedial treatment of 4-5 m2 of surface. Consumption depends on the type and absorption of the surface. Surface area m2Consumption l in one applicationThe calculation is informative. Material safety data sheets Technical data UseTechnical dataInformative calculation of consumptionMaterial safety data sheets Before use, shake bottle with Algid and thin with water at about 20 °C, in the following ratio: 1 part Algid and 4 parts water. Moisten the surface infected with algae with water first. Apply the solution with a brush, a roller, or by spraying. Protective clothing should be worn when using this product. When spraying, direct the agent to the infected surface as much as possible to avoid spraying the surrounding area. Protect nearby plants with a protective film. Only use the product at a temperature above +8 °C. The surface must not be exposed to rain while the agent is left to work.After a few hours, the algae on the surface become discolored and die. After 24 hours, brush the surface to remove the algae manually and rinse with water. Repeat the process in case of severe infestation.If needed, coat the wooden surfaces with solvent-based woodstain after cleaning; as additional protection we recommend using Belprotect.1 l of thinned agent (1:4) is enough for the remedial treatment of 4-5 m2 of surface. Consumption depends on the type and absorption of the surface. Surface area m2Consumption l in one applicationThe calculation is informative. Material safety data sheets Technical data Other products in this category BelfreshEffective agent that removes the greyness from weather-exposed wood that has turned greyHelps to emphasize the natural colour of walkable surfaces, wall cladding and garden furnitureSuitable for refreshing more resistant types of wood ... BelcareColourless water-based productFills up the micropores in the coatingImproves water-resistance of the surfaceRefreshes the colour and extends the lifespan of the coating ... BelprotectColourless coating used to improve the resistance of the coated surfaceContains additives that protect the film against mould and algaeWith Belprotect, the coated surface retains its pre-coat colourThe final appearance of the surface is glossy ...
